Description
Zodiac Cyclonx brush holder roller with closures R0722400
The Zodiac Cyclonx brush holder roller with closures R0722400 is the original cylindrical support on which the active cleaning blade brushes are mounted.
This spare part includes the brush holder roller and the closure plugs so you can renew the complete assembly when the original support is worn, damaged or warped,
restoring the full cleaning performance of your Zodiac Cyclonx pool robot.
Key features of the Zodiac Cyclonx brush holder roller
- Original Zodiac spare part for Cyclonx series pool cleaning robots.
- Cylindrical brush holder that carries the active cleaning blade brushes.
- Includes the closure plugs needed to secure the brush assembly on the roller.
- Designed to restore correct alignment, traction and cleaning efficiency.
- Manufactured in durable plastic for continuous immersion in pool water.
Technical specifications
- Brand: Zodiac
- Series: Cyclonx
- Manufacturer reference: R0722400
- Part type: Brush holder roller with closures
- Location on robot: Drive roller with mounted cleaning blade brushes
- Set contents: Brush holder roller and closure plugs
- Compatible brushes: Sheet style active cleaning brushes such as reference R0633100
Compatibility with Zodiac Cyclonx robots
This brush holder roller with closures is used on several Zodiac Cyclonx pool cleaners that are equipped with active cleaning blade brushes.
It is intended as a direct replacement for the original support piece identified by reference R0722400 in the exploded view of the cleaner.
- Zodiac Cyclonx RC 4300.
- Zodiac Cyclonx RC 4380.
- Zodiac Cyclonx RC 4400.
- Zodiac Cyclonx RC 4402.
- Other Zodiac models that specify R0722400 as brush holder roller in the parts list.
Always check the spare parts diagram or the label on the original roller to confirm that the reference is R0722400 before ordering.
If the number and design match, this part is the correct replacement for your robot.
When to replace the brush holder roller
The brush holder roller is subjected to mechanical loads from the drive system and continuous contact with pool water and chemicals.
Over time the tube or the closures can deform, crack or loosen, which may reduce contact between the brushes and the pool surface or cause abnormal noise.
- Replace the roller if it is visibly cracked, warped or broken.
- Replace the roller if the closure plugs no longer lock the brushes securely in place.
- Replace the roller if the robot vibrates excessively or the brushes do not run straight.
- Inspect the roller whenever you change the brushes for wear or deformation.
Installation and maintenance guidelines
- Disconnect the power supply from the control unit before handling the pool cleaner.
- Remove the robot from the pool and place it on a soft, stable surface.
- Remove the existing brushes and closure plugs according to the user manual.
- Slide the worn brush holder roller off its supports and check the drive system for damage.
- Position the new Zodiac Cyclonx brush holder roller R0722400 in the same orientation as the original part.
- Refit the active cleaning brushes and secure them with the supplied closure plugs.
- Verify that the roller turns freely and that the brushes are evenly seated along the full width.
After installation, run a short test cycle and observe the movement of the robot.
The cleaner should move smoothly, with the brushes maintaining consistent contact with the pool surface and without abnormal vibration.
